What Extract Rate Does a Large Bathroom or Wet Room Need?
Quick answer
Start with the extract rate your bathroom ventilation system needs to deliver. Then choose a fan that can achieve that rate through the planned duct route. For intermittent extraction in a dwelling bathroom, England’s Approved Document F gives 15 L/s (54 m³/h) as the minimum guidance figure. A fan’s rated airflow is a separate figure from the airflow measured at the grille after installation.
Which airflow figure should you compare?
| Figure | What it tells you |
|---|---|
| Required extract rate | The airflow the ventilation design needs to deliver under the guidance applicable to your project. |
| Rated fan airflow | The manufacturer’s figure under stated conditions. Check the performance curve or ask for duty data at the expected duct resistance. |
| Measured extract rate | The airflow at the extract terminal once the fan, duct and outlet are installed and the system is operating. |
The 15 L/s figure applies to intermittent bathroom extraction in the cited England guidance. Continuous systems use different guidance. Confirm the edition and rules for your project, especially outside England. See Approved Document F for ventilation in England.
How do you calculate airflow from room dimensions?
Multiply the room’s length, width and ceiling height to get its volume. If your installer specifies an air-change rate for estimating purposes, multiply the volume by that rate to get m³/h. To convert L/s to m³/h, multiply by 3.6.
Worked example: A wet room 3.5 m long, 3 m wide and 2.4 m high has a volume of 25.2 m³. At an illustrative six air changes per hour, that works out to 151.2 m³/h, or 42 L/s. Six is used here to show the calculation. Ask your installer what design rate is appropriate for your room and system.
Why does the duct route change the result?
Long runs, tight bends, crushed flexible duct and restrictive external grilles can make a fan move less air. A closed bathroom door can also restrict the incoming air needed to replace what the fan extracts. Before choosing a model, note the duct diameter, approximate length, number of bends and where it discharges outdoors. Ask the installer to assess the route and verify airflow at commissioning. Our 100 mm and 150 mm ducting guide explains what to measure.
When should you compare a 150 mm fan?
Consider one when the proposed route suits a 150 mm connection and the model’s performance data supports the required airflow. For example, our 150 mm matt black fan with humidistat and timer is rated at 255 m³/h. Use that figure to compare models, then ask what the fan is expected to deliver through your duct route. If you’re replacing a fan on existing 100 mm ducting, have the route assessed before ordering a larger model.
The bathroom extractor fan buying guide compares duct sizes, controls and replacement checks.
Common questions
Does a humidistat increase airflow?
On a single-speed fan, the humidistat controls when the fan runs. The fan and duct route determine the airflow while it is running.
Does a wet room always need a 150 mm fan?
The right diameter depends on the airflow required, the duct route and the fan’s performance under those conditions. Check all three with your installer.



